Drain engine oil and refill (special or synthetic oils subject to additional charge)

Replace oil filter

Check for general oil leaks (report any serious leaks)

Check for timing belt replacement interval & report if due according to mileage/age

Check radiator condition, security and report any leaks

Check condition of radiator cap

Check coolant hoses for leaks and condition, check securing clips for tightness and report

Visually inspect expansion bottle/tank for leaks and cap security

Check electric cooling fan for operation where applicable

Check condition and tension of fan / alternator belt, adjust or report on condition

Check condition and tension of auxiliary drive belts (excluding timing/cam belt)

Replace Air Filter

Report Spark Plugs due to be changed according to mileage, (additional charge for the supply of plugs & fitment)

Check and record antifreeze strength / min temp and top up coolant as required

Drain out cooling system and replace coolant to min of 33% antifreeze

Replace Spark plugs for petrol vehicles only (extra charge for platinum or long life plugs)

Check fuel cap condition

Check visual condition of fuel lines

Replace Diesel fuel filter (if fitted and external from fuel tank)

Replace Petrol fuel filter (if fitted and external from fuel tank)

Check clutch operation for drag/ slip/ judder/noise and adjust (if applicable)

Check & Top up clutch fluid (if applicable)

Check drive shaft gaitors for security and report leaks

Check propshaft / drive shaft/joints and grease nipples where fitted

Check and top up axle and/or transaxle oil (if applicable)

Top up gear box fluid where applicable and not sealed

Check operation of exterior lights

Check horn

Check Diesel heater plug indicator operation where fitted

Check Battery security /lubricate terminals

Top up Battery/non-sealed units only

Visual inspection of HT leads

Check external condition of distributor cap

Test effectiveness of starter motor

Test alternator charging rate - check security

Check / top-up power steering reservoir (if applicable)

Check steering / suspension components for wear and corrosion

Check steering rack gaitors condition

Check wheel bearings for excessive play or noise

Check shock absorber condition and report on any serious leaks

Grease steering / suspension (where applicable)

Inspect exhaust system inc catalyst if fitted for leaks security and noise

Visual check for exhaust smoke (Diesel)

Check brake pads for wear or damage

Check brake callipers for leaks and security

Check foot brake shoes for wear or damage

Inspect operation of wheel cylinders and report any leaks

Visually check brake hydraulic system, pipes and hoses for any leaks, chafing and corrosion

Check security of handbrake linkages and travel, lubricate and adjust if required

Check Brake discs / drums for wear, cracks, corrosion and scoring/pitting

Check Brake Fluid Level & Top Up if required

Check Brake Servo Operation

Check ABS warning light for correct operation (if applicable)

Test and report brake fluid boiling point (if applicable)

Replace Brake Fluid and bleed system

Remove Road wheels

Check tyre size and tyre fitted according to side wall instructions

Check tyre condition, tread depth, (including spare)

Check and adjust tyre pressures (including spare)

Set wheel nut torque to manufacturer’s settings

Check wheels for correct balance (including spare if applicable)

Reset vehicle service light where applicable/ subject to data & tooling availability

Road test

Stamp service book (indicating a Halfords Autocentre Menu Service has been carried out)

Lubricate bonnet catch